Installation Promise

We will not sell units that are not appropriate for your homes size, if asked to do so, We will refuse the job.  CVM has the reputation of quality and service and it will be maintained.

The goal of our installation is to lay out the most straight, most direct route of tubing and to assure you, our client, the most efficient built-in central vacuum cleaning system possible. While placing the inlet valves in the most convenient, inconspicuous and easy to use locations. CVM will not interfere with or comprise the integrity of the structure in which it is installed.

CVM will use only the highest quality virgin PVC tubing (no "regrinds" which will cause rough interior finishes). All cuts will to be made with a thin wall tubing cutter for straight clean cuts leaving no gaps between pipe and joint fittings. All pipe will be de-burred, thus assuring proper gluing and seating of pipe. Never will CVM use a hacksaw unless forced to do so. (A hacksaw will cause burrs on the inside of the pipe).

CVM will use only quality fittings which are produced in polished stainless steel molds and are 25% heavier than other fittings. All fittings will have 3/4" cuff not 1/2". I will only install (short) 90 degree elbows at the inlet valve connections and will make offset jogs with two 45degree elbows not two 90 degree elbows. I will never install dropout tees (where the sweep part of the tee goes directly on top of another inlet valve run) because debris can fall down to the unused inlet.

CVM will only install 20 gauge wire for the low-voltage wiring. Others use telephone wire which is a much smaller gauge. Wire will be secured to the pipe every 10' minimum and at most elbows with plastic tie wraps to insure a neat and safe installation.